H61N5S

This course covers monitoring, managing and configuring your edge-to-core network with the HPE Intelligent Management Center software platform (HPE IMC). This course teaches how HPE IMC is installed, how devices are added through discovery, and then how they can be viewed. The course also goes through configuration management and explains how HPE IMC is used to manage firmware and configuration on devices. It covers how alarms are received and processed in HPE IMC, along with trap management. Then it looks at the Virtualization Resource Management (VRM) component against an ESXi host. This course teaches Access Control List (ACL) management, Network Traffic Analyzer (NTA), Compliance and Intelligent Policy Center, report management, and VXLAN management. The hands-on lab exercises utilize HPE IMC working with edge devices including HPE Comware, Aruba AOS and CX and Cisco switches. This course is approximately 40 percent lecture and learning activities, and 60 percent hands-on lab activities.

This course is the combination of:

• HQ7C1S: HPE Intelligent Management Center - Managing and Monitoring your Network
• H61N0S: HPE Intelligent Management Center - Securing Network and Performance Management

HQ7C1S: HPE Intelligent Management Center - Managing and Monitoring your Network 
Detailed course outline

• Module 1: HPE Intelligent Management Center Introduction
• Module 2: Installation and Initial Access
• Module 3: Adding Devices
• Module 4: Trap Management
• Module 5: View Management
• Module 6: Configuration Management
• Module 7: Alarms and Events
• Module 8: VLAN Management
• Module 9: Performance Management 
• Module 10: Virtualization Management

H61N0S: HPE Intelligent Management Center - Securing Network and Performance Management
Detailed course outline

• Module 1: ACL Management
• Module 2: Network Traffic Analyzer (NTA)
• Module 3: Compliance Center and Intelligent Policy Center
• Module 4: Reporting
• Module 5: VXLAN Management

This course is for network administrators and engineers who plan to deploy, manage, monitor and configure their network using the HPE Intelligent Management Center software platform.

Prior to this course, students should have some networking experience to get the most from this training course. They should:

• Understand networking
• Understand IPv4 addressing
• Have some knowledge of the CLI commands on HPE Aruba Switches (AOS and CX), HPE Comware v7 and Cisco (this knowledge is beneficial, but not required)
• Understand file architecture on HPE Comware and Aruba, including Telnet/SSH, and start up and saved configurations
• Understand SNMP configuration
• Understand traps and how they are configured on the switches